Ive had my up box for about a week now, I've completed 2 smaller prints and one larger 18 hour print before I started to run into problems. I loaded up another 18 hour print and it started fine. About two hours into the print it began to air print and no more filament was passing through the nozzle. I cancelled the print and cleaned out the extruder and nozzle. Ive also cleaned the gear with some acetone and a metal bristled brush.I set up the print again and it begun like before, but soon was back to air printing. If i pause the print job I can extrude the filament perfectly. Im really confused as to why it can extrude without hassle but doesnt complete the print. Am I doing something wrong or missing a step in the printing process?
I didn't find the right solution from the Internet.
Marketing video studio
Post hier alles wat je wilt posten over fantasy-, horror- of sci-fi films en series. Bovendien hebben we hier een heleboel Anime! Ook Tv tips kom je hier te weten.
1 bericht • Pagina 1 van 1
Wie is er online
Gebruikers op dit forum: Geen geregistreerde gebruikers en 0 gasten